Kimpex HD Charging System with HD Flywheel and Aluminum Mosfet Regulator Fits Yamaha – 345100

This kit includes: a Stator, an Aluminum Mosfet Regulator, a Heavy Duty Flywheel and a Crankcase Cover Gasket and Connectors kit.

• Crankcase cover gasket included
• Connector kit included
• All products are tested

Stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius
• Connector included
• Rubber grommet included

Heavy Duty Flywheel Rotor

KIMPEX is offering a replacement flywheel for your Yamaha.
This flywheel can be used as a direct replacement to the OEM.

Features

Improved epoxy: Uses high temperature epoxy that is stronger than OEM, eliminating the possibility of magnet detachment.

High grade steel capping: Prevents heat and friction from degrading the epoxy attaching the magnets. Though extremely unlikely, if a magnet did ever come loose, it would remain in the sleeve preventing contact with the stator.

Precise balancing: Eliminates crankshaft vibrations for longer engine longevity.

Two years warranty. All products are tested.

Aluminum Mosfet Regulator

Our new red machined aluminum Mosfet voltage regulator is a great upgrade for heat dissipation in any powersports charging system. After 10 minutes of use, our billet aluminum heatsink runs cooler by 33% than standard cast regulator housings. Our new red regulator, equipped with the renowned Mosfet regulation technology, is an added value to any three-phase permanent magnet charging system.

This modern, ultra-reliable concept can handle up to 50 amps peak and 30 amps continuous 3 phase, 30 amps single phase and dissipates heat better than any OEM diode regulator. In addition, this rectifier has overheating protection, rather than burning out, it turns off for a while in order to cool down.

Features

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• The quality exceeds the OEM equipment
• Improved heat sink and charging capabilities
• Higher grade of electric components.
• All shipped products are tested

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

Why use Mosfet Enhanced technology?

Runs cooler
Runs much cooler than the traditional Shunt voltage regulator rectifier.

Saves gas
Less load on the stator, less work, less fuel is used and you save.

Regulated energy
The power charging your battery is steadier and smooth.

Extended battery life
Extends the battery’s life and cold cranking capacity.

More engine power
Removes stator load resulting in more engine power.

Optimized power
Optimize power delivery by switching the stator coils on or off.